Replacement Golf Impact Screen for an Existing Enclosure: How to Measure, Match, and Order the Right Size
Quick summary· AI-generated
The article walks readers through measuring their enclosure's interior opening dimensions (in three places to account for drift), understanding the proper gap between frame and screen for bungee attachment, matching grommets to existing anchor points, and choosing between standard Carl's Place sizes or requesting a custom build. It explains why replacing only the screen—rather than the whole enclosure—preserves projector alignment and room setup. Key takeaway: a typical 4-inch gap between frame opening and screen width (2 inches per side) prevents sagging or over-tension that can damage the screen or send balls back at the player.
Excerpt from GolfingSim - News
Four inches. Carl's Place says your enclosure's frame opening should be about that much wider than the screen hanging inside it, which works out to roughly 2 inches of room on each side for the bungees (Source: Carl's Place FAQ, via Golf Simulator Forum). Get that wrong and a brand-new screen either sags like a hammock or gets pulled so tight it fires balls back at your shins. If you're shopping for a replacement golf impact screen for an existing enclosure, that gap decides whether the swap works. Your frame is already built and it isn't moving, so the screen has to fit the frame. This guide covers how to measure the opening, how much gap and tension to leave, how to match grommets to your attachment points, and how to tell whether a standard size will work or you need a custom one. Why a Replacement Golf Impact Screen Beats Buying a Whole New Enclosure Screens wear out long before frames do. Ball marks pile up, a mishit catches the edge, or years of tension stretch the fabric until it bags in the middle. The steel or EMT pipe around it is usually fine. When you swap only the screen, your projector alignment, side netting, and mat position stay exactly where you set them. You replace the one part that takes every impact and leave everything else alone. The catch is that the new screen has to fit a frame you may not have designed. Maybe it came in a kit, or maybe you built it yourself three years ago and lost the notes. Either way, you start with a tape measure.
Already know your frame size?
Carl's Place Standard screens come in four aspect ratios and several preset heights, with custom sizes available on request. Find the one that fits your opening.
Shop Carl's Place Impact Screens
Step 1: How to Measure Your Enclosure Frame for a Replacement Screen Measure the inside of the opening, not the outside What you need is the clear space between the frame members: inside edge of the left upright to inside edge of the right, and underside of the top bar down to the bottom rail or floor. Outside measurements include the pipe thickness, which can throw you off by 2 or 3 inches. Measure in three places Measure the width at the top, middle, and bottom, and the height at the left, center, and right. Frames drift out of square, especially DIY builds and anything that's been knocked a few hundred times. Use the smallest number in each direction. Write down your attachment points and back clearance While you're up there, note every place the frame lets you tie off:…
Comments (0)
No comments yet.